Packing your Mount' Mover for shipping

In the event that you have to ship a Mount' Mover back to BlueSky Designs,
Please use the original box!

Bottom-Insert Box

1. Locate the Bottom-Insert Box

This half of the box has the cut-out securement flap that conforms to the Mount' Mover when inserted
Open up that flap.
Open the inner flap for the Bottom-Insert Box

2. Open inner flap for the Bottom-Insert Box

If you are returning a 24" post, it can fit in this compartment diagonally
Insert wrist into flap

3. Insert arm into inner flap by the wrist

With the wrist and tiltplate on the inside, insert the Mount' Mover into the "U-shaped" cutout in the flap.
The Arms, Paddle and Hoop are on the outside of the Bottom-Insert Box.
Please note that if you are sending your QRP for upgrade, you will need to return it as well. Make sure it is attached to the Mount' Mover
fold down securement flap around arm

4. Fold-in the securement flap around the Mount' Mover

If you are returning the single arm, fold this in - then skip to Step 8
Using the Hoop to expose the arm

5. Using the Hoop to expose the arm

To expose the arm to secure it with the twist tie - you will have to actuate the hoop (pull it away from the paddle) to move the arm.
Securing the arm with twist-tie

6. Securing the arm with twist-tie

With the lower arm out of the way, use the twist tie to secure the arm.
Fold the arm back into it's stowed position

7. Fold the arm back into it's stowed position

Using the hoop, move the arm back into the position shown in the picture.
Attach the Upper-Insert Box

8. Attach the Upper-Insert Box

Align the two box "arrows" and insert them into the Lower-Insert box.
Pack the combination-insert

9. Pack the stacked-inserts

If you are returning any accessories, you can pack them in this open box.
(No accessories are shown in this picture)
Padding the link

10. Padding the link

To properly secure the arm for shipping, insert the two foam blocks to isolate the link.
If you no longer have these foam blocks, you can use crumpled-up paper. A paper grocery bag works really well.
Any accessories should be padded in the same manner to make sure they do not fly around in the box during shipping.
Box up the stacked inserts

11. Box up the stacked inserts

The stacked-inserts will fit in the shipping box perfectly.
Tape up the shipping box

12. Tape up the shipping box

At least apply 3 strips of tape across the last flap to make sure it is secure.
Insert wrist into flap

13. Tape on the shipping label, and drop it off at your nearest UPS store!

Remember if you have any questions along the way,
call us at 1-888-724-7002