About the Wheelchair T-Nut (WC-TN)

The wheelchair T-Nut is used to attach to Pride Mobility (Quantum and Jazzy) and Invacare chairs with slide tracks.
You can attach Wheelchair Brackets directly to the WC-TN, or you can use other accessories for more positioning options.

• Hardware A: Two 1/4"-28 x 7/8" Bolts and Two 1/32" thick washers for attaching BlueSky Designs Adjustable Wheelchair Bracket (WB), or other adapter plates to the T-Nut (WC-TN)
• Hardware B: Two 1/4"-28 x 5/8" Bolts for attaching a solid Wheelchair Bracket (WB2) to the WC-TN

Wheelchair T-Nut (WC-TN)

Slidetrack rail example

Attaching a T-Nut to Slidetrack

 back to top

Example 1: Mounting to a Slidetrack frame that typically is at an angle.

   

This primary operating position for this client was tilted at a slight angle.
To maintain a vertical post, the WB (adjustable) was used.

Components used: Wheelchair T-Nut (WC-TN), Adjustable Wheelchair Bracket WB(adjustable)

---

Example 2: Mounting to a Slidetrack frame that typically is at an angle.

   

Mounted similarly to the set-up shown in Example 1, this client had an additional ECU display that was not obstructed.
In addition to this wheelchair, the client had a manual tilt-in-space wheelchair that was also mounted to.
This enabled him to have full access to his device in either chair, without changing any settings.

Components used: Wheelchair T-Nut (WC-TN), Adjustable Wheelchair Bracket WB(adjustable)

---

Example 3: Mounting to a Slidetrack frame where the push-up post is obstructing ideal mount placement.

     

Refer to the center picture, where the post would sit outside of the armrests but still within the wheelchair footprint.
This scenario required the use of a Wheelchair L-Angled Extension Plate (WC-LAE) to offset the post mounting.
A WB(adjustable) was used, but a simpler set-up could be accomplished using the the WB2(Solid).

Components used: Wheelchair T-Nut (WC-TN), Wheelchair L-Angled Extension Plate (WCLAE), and the Adjustable Wheelchair Bracket WB(adjustable)

---

Example 4: Mounting to a Slidetrack frame where a large laptray is obstructing ideal mount placement.

   

This client had a large laptray that they wanted to dodge, which requirements an extra offset
Using two WC-LAE components and a WC-AP, the mount was offset roughly 5" outside of the seat rail.
We do not recommend using more than two WC-LAE components for offsets, as this severly increases the moment arm on the support.

Components used: Wheelchair T-Nut (WC-TN), Wheelchair Adapter Plate (WC-AP), two Wheelchair L-Angled Extension Plate (WCLAE), and a Solid Wheelchair Bracket WB2(solid)

---

These are only a few examples of how some people have successfully mounted to their wheelchairs.
We understand that every case is different, so If you have any questions about mounting or the Mount'n Mover in general,
email us, or call us at 1(888)724.7002 / 1(612).724.7002.

 back to top