Frontier V6

The Frontier V6 has threaded holes for M8 bolts on the seat frame. The Adapter Plate 4 has M8 holes and an M8 slot. The hole and slot should accommodate the bolt spacing.
The bolts to be used are on a square tube with 8mm threading. See the hex head bolts.
Inside view of bolts through the seat frame shows they extend beyond the frame. so they can be removed and used with an Adapter Plate.

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Attach an Adapter Plate 4, using two M8 bolts. Remove the two bolts closest to the front of the seat, on the side of the seat frame. . Put the bolts through the M8 hole and slot combination on the AP4. At this point, the AP4 may be at an angle. Use the Angle Adjust Plate to ensure the Wheelchair Bracket is mounted so the post is vertical.

Installation support: 

Suggested extra parts

Other hardware: 

M8 bolts already installed may work, but they may need to be longer.