Mygo Stander

Approach 1: Mygo Stander, attached with plates and bridge clamp
Approach 2: The Post Extension Kit allows placement of the post further forward, with fewer plates and can be adjusted.
Adapter Plate is attached to frame with 7/8 bridge clamps; Angle Adjustment Plate attached to create vertical attachment
Attach pair of L-Angle Extension plates to offset for tray width. Attach the Wheelchair Bracket
Add additional offset plates if needed--to move the Wheelchair Bracket forward. Or consider Approach 2, with a Post Extension Kit.
Adapter Plate is attached to frame with 7/8 bridge clamps; Angle Adjustment Plate attached for vertical attachment
Insert horizontal post, with a Wheelchair Bracket on the end to receive the mount post.

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Attach to the round frame just behind the upright supports with a Bridge clamp (two 7/8" bridge clamps and an Adapter Plate 4).

Attach an Angle Adjustment Plate to the AP4. Add a pair of L-Angle Extension plates to offset it for the tray width. Attach a Wheelchair Bracket for the Mount'n Mover post.

Instruction sheet: PDF icon Mygo Stander Instructions.pdf

Installation support: 

How to mount: 

Attach to the round frame just behind the upright supports with a Bridge clamp (two 7/8" bridge clamps and an Adapter Plate 4).

Attach an Angle Adjustment Plate to the AP4.

Attach a Post Extension Kit, to extend the Wheelchair Bracket further forward.

Installation support: