Mygo Seat

The Mount'n Mover is attached and can be positioned where it is needed.
Remove the strap plate and bolts to allow attachment of the Adapter Plate.
Attach the Adapter Plate 4, threaded holes towards the front and outer edge of the seat.
Threaded holes allow reattachment of the Adapter plate and strap plate.
An L-Angle Extension is shown attached to offset/reposition the Wheelchair Bracket.
Attach the Wheelchair bracket, and you're ready to set up the Mount'n Mover!
Set up for an eye-gaze system on a Kimba Neo!

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Sandwich an Adapter Plate with existing components. Use an L-Angle Extension to Offset it.

The reason to attach to the Seat is two-fold: it will tilt with the child as their seat tilt angle is adjusted; and if they use the seat in a different base, the mount will go with them.

An alternate approach would be to attach to the Kimba Neo stroller. See Ottobock Kimba Neo for details.

Installation support: 

Suggested extra parts

Other hardware: 

Longer hardware may be needed to attach to the aluminum plate with threaded holes.