KimbaNeo-NUTEC seat

OttoBock Kimba Neo Stroller
Kimba Neo clamp conforms exactly to the tube and offers a number of mounting positions to get the right angle.
Attach Kimba Neo Clamp to tube as shown
Attach the Adapter Plate to the KimbaNeo clamp so it is horizontal, extending forward.
Wheelchair Bracket is attached, and ready for a Mount'n Mover!
Approach 2: Sandwich the Adapter Plate between the tube plate and the seat bottom. Align a hole and slot with the bolts. Orient the Adapter Plate so threaded holes are out and forward.
Attach an L-Angle to the Adapter plate with 2 bolts, and then attach the Wheelchair Bracket. Ready to go!
Attach an iPad and away you go!

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Attach a KimbaNeo clamp to the oval tube.

Attach an Adapter Plate to the NT-KNAC clamp with the bolts supplied. Attach to threaded holes that allow for a horizontal orientation of the Adapter Plate.

Attach the Wheelchair bracket to the Adapter Plate.


Installation support: 

How to mount: 

A NUTEC Custom Configured seat is shown on the Kimba Neo base.

Approach 2: Attach to bottom of the seat, sandwiching existing seat hardware

Remove the round tube plate near the front of the underside of the seat. Place an Adapter Plate 4 between the seat and the round tube plate. Reinsert bolts (or get slightly longer ones).

Attach an L-Angle Extension to provide a vertical attachment face for the Wheelchair Bracket, and attach the WB2.

Installation support: