PR30

The PR30 legrest assembly is attached with two 8mm bolts.
The two bolts used to attach the legrest assembly will be replaced with two that are 6mm longer to accommodate the Adapter Plate thickness.
Align the 8mm slot and hole on the Adapter Plate 4 with the two holes currently in use. Remove those bolts and replace with longer ones. Be careful to replace the legrest assembly in the same position.

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Mount an Adapter Plate 4 to the outside of the legrest bracket, using the same holes currently in use. Remove the existing bolts and replace with bolts that are 6mm longer.

Attach Offsets such as an L-Angle Extension or another Adapter Plate to position the Solid Wheelchair Bracket where needed.

Installation support: 

Suggested extra parts

Other hardware: 

M8 bolts (2); find out bolt length and add 6mm for the Adapter Plate 4 thickness; replace bolts which attach footrest assembly.